MVA - Sleeve Sandwich Panel Anchors
Datos del producto
- Fabricante:
- HALFEN
- Código del producto:
- MD-HAEBMVAKZPW
- Categoría:
- Fachada de hormigón
Compartir
Descripción del producto
HALFEN offers two different systems for anchoring the facing layer of sandwich panels to the supporting shell:
SPA sandwich panel anchors as well as MVA sleeve sandwich panel anchors and FA flat anchors. In both systems the support armature assume the function of transferring the dead weight of the front panel, and a proportion of horizontal forces from the effects of wind and temperature into the base course.
Two support anchors are usually enough for this: 2 FA or 1 MVA and 1 FA.
- If using two FA anchors, they should be symmetrical to the fulcrum in every direction. Another bearing anchor should be inserted as a horizontal anchor, perpendicular to the main direction of the load.
- When using the MVA and FA is the cylindrical anchor is placed in the anchoring centre, and the FA on the same fulcrum. With this combination, the FA simultaneously assumes the function of the torsion anchor.
Additional, officially approved connector pins and/or connector brackets or clip-on pins are installed in the remaining area of the plate to transfer the horizontal forces and prevent the facing layer from warping.
When properly arranged, they minimise the constraining forces caused by from thermal expansion and warping of the facing layer through the construction of the MVA/FA anchor.
Through the round holes in the anchor ends the MVA and FA can be securely tied to the existing reinforcement before pouring in the concrete, by using reinforcing steel sections.
Quality features:
- quicker to install
- absorption of high loads
- also suitable for large unit dimensions
- building authority approved
- planning made simple with the free software from HALFEN
- CE-marking acc. to EN 1090