ATLAS PLUS MEGA - deformable S1 adhesive for large size floor tiles (C2E type)
Product details
- Producer:
- ATLAS
- Product code:
- MD-APMKOS1TC2E
- Category:
- Tile Adhesives
- Collection:
- ADHESIVES FOR TILES
Share
Product description
Description
2 in 1 – levels the substrate and fixes tiles at the same time – it is a thick layer (up to 2 cm) adhesive for floor tiles, no additional surface leveling necessary.
It is recommended for fixing tiles exposed to extremely difficult usage conditions – caused by non-standard deformation of the substrate and adverse weather conditions.
Enables fixing tiles on difficult substrates – like: OSB panels, terrazzo, "tile on tile", as well as strongly adhesive paint coatings (e.g. oil paint dado), bitumen (after parquets) and adhesives (after PVC tiles), etc.
The main characteristics
• pourable, thick-layer 4-20 mm
• high plasticity, adhesiveness and deformability S1
• perfectly fills the space under the tile • for difficult substrates – OSB panels, old tiles, terrazzo
• for terraces, balconies, floor heating systems
The main parameters
• consumption: ca. 1.5 kg of dry mix / 1 m² / 1 mm adhesive layer
• deformability S1
• bed thickness: 4 - 20 mm
• high adhesion: ≥ 1 N/mm²
Series description
Classification of adhesives for tiles
Adhesives for tiles are classified and marked according to PN-EN 12004 Standard
The Standard specifies three types of adhesives:
C – cement based adhesives
D – dispersion adhesives
R – adhesives based on reactive resins
Each of the above types of adhesives can appear in different forms (classes) corresponding to additional requirements:
1 – standard setting adhesives – adhesion after 28 days ≥ 0.5 N/mm2
2 – adhesives of improved parameters – increased adhesion, after 28 days ≥ 1.0 N/mm2
F – fast setting adhesives – adhesion ≥ 0.5 N/mm2, measured after time not exceeding 6 hours
T – adhesives with reduced slip – slip not exceeding 0.5 mm
E – adhesives with extended open time – adhesion after 28 days ≥ 0.5 N/mm2, despite the fact the time between the application of the adhesive and placing a tile is not shorter than 30 minutes.
Adhesive selection
Before fixing ceramic tiling or natural stone, please pay attention to a few elements significant for the proper selection of the adhesive.
These are:
- substrate – the material it is made of, its absorptive power, roughness, adhesiveness, cleanliness, maturing degree and possible deflection
- tiles – their kind (gres-porcelain, terracotta, glazed tiles, stone), size (mosaic, large size), absorptive power and resistance to discolouration
- conditions of use of the tiling – the atmospheric influence (indoor, outdoor), situation (wall or floor), kind and volume of usable load (pedestrian or vehicle traffic), frequency and the volume of temperature changes.
Additional Resources
Catalogue
catalogue.pdf
1.96 MBkatalog.pdf
7.5 MB
